Generally, CO2 laser engraving machine
is used, but it depends on what kind of glass it is. Some glass surface will burst and scratch hands after engraving
. Generally, laser equipment is not used for engraving
, and the most common method is to use that kind of liquid medicine to corrode and make frosting effect.
Glass that can be carved by laser
is usually quartz glass, crystal glass, tempered glass, etc. it is suggested to try the carving effect first.
can be divided into dot matrix engraving and vector cutting according to different engraving methods: dot matrix engraving dot matrix engraving is similar to high-definition dot matrix printing. The laser head swings left and right to carve a line composed of a series of points each time. Then the laser head moves up and down at the same time to carve multiple lines, and finally forms a full page image or text, such as a high-grade cosmetics display rack with complex carving. Dot matrix engraving can be used for scanned graphics, text and vectorized graphics. Vector cutting is different from dot matrix carving. Vector cutting
is carried out on the outer contour line of graphics and text. We usually use this mode to cut through wood, acrylic, paper and other materials, and we can also do laser marking
on a variety of materials.
The performance of a engraving machine
is mainly determined by engraving speed, engraving intensity and spot size. Engraving speed engraving speed refers to the speed of laser head movement, usually expressed in IPS (inch / second). High speed brings high production efficiency. Speed is also used to control the depth of cutting. For a specific laser intensity, the slower the speed, the greater the depth of cutting or carving.
You can use the engraving machine panel to adjust the speed, you can also use the computer's print driver to adjust. In the range of 1% to 100%, the adjustment is 1%. The advanced motion control system enables you to get super fine engraving quality when engraving
at high speed. Engraving intensity refers to the intensity of laser beam on the material surface. For a specific engraving machine speed, the greater the intensity, the greater the depth of cutting or carving. You can use the engraving machine
panel to adjust the intensity, you can also use the computer's print driver to adjust. In the range of 1% to 100%, the adjustment is 1%. The greater the strength, the greater the speed. The deeper the cutting depth is, the larger the spot size can be adjusted by different focal length lens. The lens with small spot is used for high resolution engraving. Large spot lens is used for low resolution engraving
, but it is the best choice for vector cutting. The standard configuration of the new equipment is 2. 0 inch lens. Its spot size is in the middle, which is suitable for various occasions.