Marking machine conveyor belt manual

1、 Operation steps

  1. Place the pipe fitting on the conveyor belt and close to the positioning rod, so as not to block the photoelectricity( The red light will be on when the photoelectricity is blocked, and the red light will be off when the opposite signal is detected. Make sure that the red light on the photo is off)
  1. Press the positioning test button, the conveyor belt starts to run, when the pipe runs to the photoelectric position and stops, press the stop key.
  1. Adjust the positioning rod and move the equipment in the north-south direction, so that the laser red alignment center of the marking machine is facing the pipe fitting, and the positioning is completed. At this time, take down the photoelectric pipe fitting, press the positioning test button again, and press the stop key after confirming the accurate position. Positioning is complete.

 

  1. Put a pipe under the laser alignment center, turn the time setting knob to the right to make the running light on, and then start marking. After marking, turn the time setting knob back immediately, and the equipment will record the laser marking time.
  1. Take down the photoelectric pipe fitting, and press the automatic operation button, the conveyor belt will start automatic operation and marking.
Laser engraving machine DIY

2、 Button description

  1. Running light: the light will be on during automatic operation, positioning test and time setting.
  1. Emergency stop: press the emergency stop to stop the equipment immediately. If the marking is in progress, it will stop after the marking is finished. If you want to stop the marking immediately, please press the emergency stop on the marking machine.
  1. Time setting: turn the time setting knob to the right, the running light will be on, and the laser will mark once. After breaking back, the equipment will automatically record the marking time, for example, the marking time is 6 seconds, then each conveyor belt will stay under the marking machine for 6 seconds and then continue to run. After the power is cut off, the system will automatically restore the default marking time of 60 seconds. Note: reset the time after each model change or power failure. Note: as the laser will mark when this button is pressed, the pipe fittings must be placed under the laser head.
  1. Automatic operation: when the positioning and time are set, press this button, the device will run automatically. Note: do not put the pipe fittings before the light switch is pressed.
  1. Positioning test: press this button, the device will automatically run, but not mark, to check whether the position is accurate( The only difference between this button and the auto run button is that the button is pressed without marking. Note: do not put the pipe fittings before the light switch is pressed.
  1. Stop: when the equipment is in automatic operation and positioning test, press the stop button to stop the equipment, which is the same as the emergency stop function. If you are in the process of marking, it will stop after marking. If you want to stop marking immediately, please press the emergency stop button on the marking machine.

3、 Troubleshooting

  1. No automatic operation. Reason: check whether the photoelectric is blocked and whether the two photoelectric are aligned( The red light is on when the photoelectricity is blocked, and the red light is off when the opposite signal is detected.)
  1. The conveyor belt will not move after marking. Reason: reset the time just after power transmission.
  1. The conveyor belt moves before marking. Reason: reset the time and make it longer.
  1. The running light is always on. Reason: the time setting button is not broken back.
Metal laser engraving machine

4、 Input output table

Emergency stop: i0.0

Automatic operation: i0.1

Location test: i0.2

Stop: i0.3

Time setting: i0.4

 

Photoelectric: i0.5